Comtrol Rocket Port Manual do Utilizador descarregar pdf (Página 30)

34 - Configuring COM Port Properties RocketPort Series/RocketModem IV Driver User Guide: 2000564 Rev. A

Device Driver Configuration

Configuring COM Port Properties

This section discusses COM port configuration procedures for RocketPort ports. If

you want to change the starting COM port number on the RocketPort, see

Configuring Device Properties

on Page 32.

If your application does not set COM port properties, use the Device Manager to

access Ports (COM & LPT) to change the port parameters. If the application sets

COM port properties, those settings take precedence over Windows COM port

settings. The exception to this guideline is if you use the Override and Lock Baud

Rate to option.

Use the following procedure to change COM port settings on a RocketPort

port or

ports.

Do not connect RS-422/485 devices until the appropriate port interface

type has been configured in the driver. The driver default port setting

is RS-232.

1. Open Comtrol Drivers Management Console (Accessing the Comtrol Drivers

Management Console on Page 27).

2. Highlight the appropriate RocketPort.

3. Highlight the first port you want to configure.

Click Ok to save the changes made on this page and close

the Comtrol Drivers Management Console.

Cancel Cancels any changes made on this page.

Apply

Click Apply to save the settings on this page. If you do not

click Apply before leaving this page, you will be prompted

to Apply or Cancel the changes.

Device General Tab Description

Caution

RocketPort/RocketModem (Universal PCI) Port General Tab

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 65 66

Sem comentários

Comtrol Rocket Port Manual do Utilizador Página 30